Dog can end tables can be almost any size to fit a dog. The plans for your dog crate end table may vary depending on the size of the dog and the end table you want to build. But the materials and techniques should be the same. Dog crate must be dimensioned for your dog, neither too big nor too small. Ideally, the box should be big enough for the dog to be able to hit a complete circle comfortably in the box. But no more than 12 inches larger than the dog at height, width or depth.
The length of the table must be the length of your dog from the tip of the nose to the bottom of his tail plus 12 inches. So if the dog was 25 inches long, the box would ideally be 37 inches long. These measurements can be adjusted somewhat to make the furniture fit into the decor, but they should not vary too much. To build dog crate furniture diy, the necessary materials will include two of the tore for the frame. 3/4 inch thick white wood plates that are 6 inches long. One of the tiers for trim and one of the tiers or one of the fours for the frame by the door. You also need two small hinges and a small lock for the door. Simple plywood can used for floor and back.
24 Photos Gallery of: Diy Dog Crate End Table
But a nicer furniture grade wood must be applied to the top for a better quality finished look. For screening in the door and pages, you can choose to use one of the tiers or smaller slats of wood or just use the screen or wire mesh. Use 6-inch sheets to the sides of the table leaving a large gap of four inches or more. This between two of them against the top of the box to allow air to flow through and for the dog to look. This is where you want either the screen in the area. Or install the small-arm boards to create bars to keep your dog inside the double dog crate furniture box. You can make the inner frame for all the walls on one of them.
Or one of the towers by just making a square or rectangular frame. And then attaching 6-inch boards to them. If the box will sit against a wall, using a simple piece of plywood will be sufficient. Or you may want to create one back using the same method as the pages. The main door can done by either creating a double frame or fixing the screen. Or masking the frames so that the dog will not be able to chew on it. Or by attaching small slats to the door to make bars. Use two hinges to secure the door. And if you use that box for training, do not forget to attach a lock.